104
2-1. Instrument cluster
The meters and display illuminate when
■
The engine switch is in IGNITION ON
mode.
Outside temperature display
■
In the following situations, the correct
●
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
When "_ _"or "E" is displayed, the system
●
may be malfunctioning.
Take your vehicle to your Lexus dealer.
Pop-up display
■
In some situations, such as when a switch
●
operation is performed, a pop-up display
will be temporarily displayed on the
multi-information display or the odome-
ter/trip meter screen (F SPORT models).
Some pop-up displays can be set on/off.
●
(P.111)
Customization
■
The meter display can be customized on
the multi-information display. (P.405)
RC350-RC300_OM_General_OM24884E
WARNING
The information display at low tem-
■
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low temper-
atures, the information display monitor
may respond slowly, and display changes
may be delayed.
For example, there is a lag between the
driver's shifting and the new gear number
appearing on the display. This lag could
cause the driver to downshift again,
causing rapid and excessive engine brak-
ing and possibly an accident resulting in
death or injury.
NOTICE
To prevent damage to the engine and
■
its components
Do not let the indicator needle of the
●
tachometer enter the red zone, which
indicates the maximum engine speed.
The engine may be overheating if the
●
engine coolant temperature gauge is
in the red zone (H). In this case, imme-
diately stop the vehicle in a safe place,
and check the engine after it has
cooled completely. (P.386)
Odometer and trip meter dis-
play
Display items
■
Odometer
Displays the total distance the vehicle has
been driven.
Trip meter A/trip meter B
Displays the distance the vehicle has been
driven since the meter was last reset. Trip
meters A and B can be used to record and
display different distances independently.