Table of Contents
Advertisement
286
5-5. Using the other interior features
Perform
performing 2.
3
Press and hold the desired
HomeLink
vehicle) for 2 seconds and release
it. Repeat this sequence
(press/hold/release) up to 3 times
to complete programming.
If the garage door opener motor operates
when the HomeLink
the garage door opener motor recognizes
the HomeLink
Enabling 2-way communication
■
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
RC350-RC300_OM_General_OM24884E
3
within 30 seconds after
®
button (inside the
®
button is pressed,
®
signal.
is a compatible device. (To check
device compatibility, refer to
www.homelink.com.)
1
Within 5 seconds after program-
ming the garage door opener has
been completed, if the garage door
opener motor is trained to
®
HomeLink
, both garage door
operation indicators will flash rap-
idly (green) and the light on the
garage door opener motor will
blink twice, indicating that 2-way
communication is enabled.
If the indicators do not flash, perform
3
within the first 10 presses of the
®
HomeLink
button after programming
has been completed.
2
Press a programmed HomeLink
button to operate a garage door.
3
Within 1 minute of pressing the
®
HomeLink
button, after the
garage door operation has
stopped, press the "Learn" or
"Smart" button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that
2-way communication is enabled.
Reprogramming a single
■
®
HomeLink
button
When the following procedure is per-
formed, buttons which already have
2
and
®
Advertisement
Table of Contents
