Table of Contents
Advertisement
Canceling and resuming the
speed control
1
Pulling the lever toward you can-
cels the speed control.
The speed control is also canceled when
the brake pedal is depressed.
2
Pushing the lever up resumes the
cruise control and returns vehicle
speed to the set speed.
However, cruise control does not resume
when the vehicle speed is approximately
40 km/h (25 mph) or less.
Approach warning (vehi-
cle-to-vehicle distance control
mode)
When your vehicle is too close to a
vehicle ahead, and sufficient automatic
deceleration via the cruise control is
not possible, the display will flash and
the buzzer will sound to alert the driver.
An example of this would be if another
driver cuts in front of you while you are
following a vehicle. Depress the brake
pedal to ensure an appropriate vehi-
cle-to-vehicle distance.
RC350-RC300_OM_General_OM24884E
4-5. Using the driving support systems
Warnings may not occur when
■
In the following instances, warnings
may not occur even when the vehi-
cle-to-vehicle distance is small.
When the speed of the preceding
vehicle matches or exceeds your
vehicle speed
When the preceding vehicle is
traveling at an extremely slow speed
Immediately after the cruise control
speed was set
When depressing the accelerator
pedal
Selecting constant speed con-
trol mode
When constant speed control mode is
selected, your vehicle will maintain a
set speed without controlling the vehi-
cle-to-vehicle distance. Select this
mode only when vehicle-to-vehicle dis-
tance control mode does not function
correctly due to a dirty radar sensor,
etc.
1
With the cruise control off, press
and hold the "ON/OFF" button for
1.5 seconds or more.
Immediately after the "ON/OFF" button is
221
4
Advertisement
Table of Contents
