Lexus RC 350 2019 Owner's Manual page 143

Hide thumbs Also See for RC 350 2019:
Table of Contents

Advertisement

Press the "SET" button.
Press button "1", "2" or "3".
Operate any of the seat adjustment
switches (only cancels seat position
recall).
Operate the tilt and telescopic steering
control switch (only cancels steering
wheel position recall).
Seat positions that can be memorized
(P.136)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
Operating the driving position memory
after turning the engine switch off
Recorded seat positions can be activated
up to 180 seconds after the driver's door is
opened and another 60 seconds after it is
closed again.
In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
Registering/canceling/recall a
driving position to an electronic
key (including a card key) (mem-
ory recall function) (vehicles
with memory recall function)
Registering procedure
Record your driving position to button
"1", "2" or "3" before performing the
following:
Carry only the key you want to register,
and then close the driver's door.
If 2 or more keys are in the vehicle, the
driving position cannot be recorded
properly.
RC350-RC300_OM_General_OM24884E
3-3. Adjusting the seats
1
Check that the shift lever is in P.
2
Turn the engine switch to IGNI-
TION ON mode.
3
Recall the driving position that you
want to record.
4
While pressing the recalled button,
press and hold the door lock switch
(either lock or unlock) until the
buzzer sounds.
If the button could not be registered, the
buzzer sounds continuously for approxi-
mately 3 seconds.
Cancelation procedure
Carry only the key you want to cancel
and then close the driver's door.
If 2 or more keys are in the vehicle, the
driving position cannot be canceled
properly.
1
Turn the engine switch to IGNI-
TION ON mode.
2
While pressing the "SET" button,
press and hold the door lock switch
(either lock or unlock) until the
buzzer sounds twice.
If the button could not be canceled, the
buzzer sounds continuously for approxi-
mately 3 seconds.
141
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc 300 2019

Table of Contents