21
Turn the compressor switch on to
inflate the tire until the recom-
mended tire inflation pressure is
reached. Drive for about 5 km (3
miles) and then perform step 19.
22
Attach the air release cap to the
end of the hose.
If the air release cap is not attached, the
sealant may leak and the vehicle may get
dirty.
23
Store the bottle in the trunk while it
is connected to the compressor.
24
Taking precautions to avoid sud-
den braking, sudden acceleration
and sharp turns, drive carefully at
under 80 km/h (50 mph) to your
Lexus dealer that is less than 100
km (62 miles) away for tire repair
or replacement.
After a tire is repaired with the emer-
■
gency tire puncture repair kit
The tire pressure warning valve and
●
transmitter should be replaced.
Even if the tire inflation pressure is at the
●
recommended level, the tire pressure
warning light may come on/flash.
If the tire is inflated to more than the
■
recommended level
1
Disconnect the hose from the valve.
Install the air release cap to the end of
2
the hose and push the protrusion on the
RC350-RC300_OM_General_OM24884E
7-2. Steps to take in an emergency
air release cap into the valve to let some
air out.
3
Disconnect the hose from the valve,
remove the air release cap from the
hose and then reconnect the hose.
4
Turn the compressor switch on and wait
for several seconds, then turn it off.
Check that the air pressure indicator
shows the recommended level.
(P.400)
If the air pressure is lower than the rec-
ommended level, turn the compressor
switch on again and repeat the inflation
procedure until the recommended
pressure is reached.
WARNING
When fixing the flat tire
■
Stop your vehicle in a safe and flat
●
area.
Do not touch the wheels or the area
●
around the brakes immediately after
the vehicle has been driven.
After the vehicle has been driven, the
wheels and the area around the brakes
may be extremely hot. Touching these
areas with hands, feet or other body
parts may result in burns.
Connect the valve and hose securely
●
with the tire installed on the vehicle.
If the hose is not properly connected to
●
the valve, air leakage may occur or
sealant may be sprayed out.
If the hose comes off the valve while
●
inflating the tire, there is a risk that the
hose will move abruptly due to air
pressure.
375
7