Lexus RC 350 2019 Owner's Manual page 286

284 5-5. Using the other interior features
If learning failed when registering a dif-
●
ferent code to a HomeLink
already has a code registered to it, the
already registered code will not be
erased.
WARNING
When programming a garage door or
■
other remote control device
The garage door or other device may
operate, so ensure people and objects
are out of danger to prevent potential
harm.
Conforming to federal safety stand-
■
ards
Do not use the HomeLink
transceiver with any garage door opener
or device that lacks safety stop and
reverse features as required by federal
safety standards.
This includes any garage door that can-
not detect an interfering object. A door
or device without these features
increases the risk of death or serious
injury.
When operating or programming
■
HomeLink
Never allow a child to operate or play
with the HomeLink
Programming the HomeLink
Before programming HomeLink
■
 During programming, it is possible
that garage doors, gates, or other
devices may operate. For this rea-
son, make sure that people and
objects are clear of the garage door
or other devices to prevent injury or
other potential harm.
 It is recommended that a new bat-
RC350-RC300_OM_General_OM24884E
®
button that
®
compatible
®
®
buttons.
®
®
tery be placed in the remote control
transmitter for more accurate pro-
gramming.
 Garage door opener motors manu-
factured after 1995 may be
equipped with rolling code protec-
tion. If this is the case, you may need
a stepladder or other sturdy, safe
device to reach the "Learn" or
"Smart" button on the garage door
opener motor.
Programming HomeLink
■
1 Press and release the HomeLink
button you want to program and
check that the HomeLink
tor light flashes (orange).
Perform 3 within 60 seconds of
indicator light will stop flashing and pro-
gramming will not be able to be com-
pleted.
2 Point the remote control transmit-
ter for the device at the rear view
mirror, 25 to 75 mm (1 to 3 in.)
®
from the HomeLink
®
Keep the HomeLink indicator light in
view while programming.
Garage door type A

3 Press and hold the handheld trans-
mitter button until the HomeLink
®
®
®
indica-
1 , or the
buttons.
®