warning display may not operate prop-
erly.
Automatic turn-off of RSA sign display
■
One or more signs automatically turn off in
the following situations.
A new sign is not recognized for a certain
●
distance.
The road changes due to a left or right
●
turn, etc.
Conditions in which the function may
■
not operate or detect correctly
In the following situations, RSA does not
operate normally and may not recognize
signs, display the incorrect sign, etc. How-
ever, this does not indicate a malfunction.
The camera sensor is misaligned due to a
●
strong impact being applied to the sen-
sor, etc.
Dirt, snow, stickers, etc. are on the wind-
●
shield near the camera sensor.
In inclement weather such as heavy rain,
●
fog, snow or sand storms
Light from an oncoming vehicle, the sun,
●
etc. enters the camera sensor.
The sign is dirty, faded, tilted or bent, and
●
if an electronic sign, the contrast is poor.
All or part of the sign is hidden by the
●
leaves of a tree, a pole, etc.
The sign is only visible to the camera sen-
●
sor for a short amount of time.
The driving scene (turning, lane change,
●
etc.) is judged incorrectly.
Even if it is a sign not appropriate for the
●
currently traveled lane, such a sign exists
directly after a freeway branches, or in an
adjacent lane just before merging.
Stickers are attached to the rear of the
●
preceding vehicle.
A sign resembling a system compatible
●
sign is recognized.
The vehicle is driven in a country with a
●
different direction of traffic.
Side road speed signs may be detected
●
RC350-RC300_OM_General_OM24884E
4-5. Using the driving support systems
and displayed (if positioned in sight of the
camera sensor) while the vehicle is
traveling on the main road.
Roundabout exit road speed signs may
●
be detected and displayed (if positioned
in sight of the camera sensor) while
traveling on a roundabout.
When driving vehicle in country with dif-
■
ferent speed unit
Since RSA recognizes signs based on the
set unit of the meter, it is necessary to
change the set unit of the meter. Adjust the
set unit of the meter to the speed unit of
signs in the current location. (P.405)
Turning the system on/off
■
1
Select
on the settings display
(P.106)
2
Press
on the steering wheel.
Speed limit sign display
■
If the engine switch was last turned off while
a speed limit sign was displayed on the
multi-information display, the same sign dis-
plays again when the engine switch is
turned to IGNITION ON mode.
Customization
■
Setting (e.g. speeding warning threshold)
can be changed.
(Customizable feature:P.405)
215
4