Configuring The Serial Ports - Powerware Plus 80 Operation

Configuring the Serial Ports

Before you,connect
port for communications, using the LCD screen and pushbuttons on the UPS Monitoring
Panel.
Select Port I or Port 2 from the Setup menu to display one of the Setup Port screens. The
I
screens for Port 1 and Port 2 are identical, and allow you to specify settings for the two
I
I
I
I
I
I
-
I
A small retum'ahow (p) appears in the upper right comer of the Port Setup screen.
This arrow is a reminder that you can press the
to toggle me pushbuttons between the menu box and
I
If the scroll bar is in the menu box, press
area. The first setting (MODE) is highlighted. Press the
I
highlight to the setting you want to change.
setting, press the Q or 0 pushbutton. To save the settfngs upon exit from this screen be
sure the SAVE field is set to YES.
I
Table C on page 7 shows which options are available for each port The sections that
follow describe the configuration settings you can change.
I
6
communications equipment to a serial port, you must configure the
-
To scroll through the available options
,
for that
Plus 60 UPS Communications