Powerware Plus 80 Operation page 112

installation of stand-alone batt8r-y
page 36 and Drawing 164200253-7 on page A-16 for the location of items
mentioned in these prOC8dUreS.
1.
Unlock the left side door of the battery Cabinet using the key provided. Open
the door (press the top of the door latch, twist the latch lever clockwise 90', and
pull the door outward).
2. Remove the screws securing the right side door and open the door. Save the
WARNING:
LETHAL VOLTAGE WILL BE PRESENT WHEN
REMAINING STEPS IN THIS SECllON AND SUBSEQUENT SECTIONS.
4. lf you ar8 installing more than one battery cabinet, perform steps 1 through 3 for
each cabinet.
To wh stand-alone TLpe 2 battery cabinets
connector, and remove the tiewrap See Figure 22 on page 36 for connector
locations.
2. In the adjoining cabinet to the left, remove the screws securing th8 right Cab18
3. Mate the left cable connector to the right cable connector in the adjoining
cabinet to the left
4. Repeat steps 1 through 3 of this procedure for each battery cabinet to be joined.
cabinets (see page 17). Refer to figure 22 on
stand-alone
PERFORMING
together:
THE