Table of Contents
Advertisement
13.4 Configuring the Serial Ports
You must configure the port for communications using the LCD screen and
pushbuttons on the SSBM Monitor Panel.
Select Port 1 or Port 2 from the Setup menu to display one of the Setup Port
screens. The screens for Port 1 and Port 2 are identical, and allow you to specify
settings for the two serial communication ports. Figure 13---3 shows the Setup
Serial Port 1 screen.
UPS System Normal
ALARM:
NONE
NOTICES: NONE
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters
Events
A small return arrow (
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area.
If the scroll bar is in the menu box, press the
information area. The first setting (Mode) is highlighted. Press the
pushbutton to move the highlight to the setting you want to change. To scroll
through the available options for that setting, press the
To save the settings upon exit from this screen, be sure the Save field is set to YES.
13--4
Uninterruptible Power System
Mode
TERMINAL
Statistics Graphics
Figure 13---3. Setup Serial Port 1 Screen
) appears in the upper right corner of the Setup Port
15 JUL 1998
Setup Serial Port 1
Rate
Data/Stop
Handshaking
9600
8
1
XON / XOFF
Setup
pushbutton to toggle to the
Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM
09:25:42
Save
NO
pushbutton on the
or
or
pushbutton.
164201373 Rev. A
092402
Advertisement
Table of Contents
