Connecting Equipment To A Serial Port - Powerware Plus 80 Operation

1
I

Connecting Equipment to a Serial Port

You can connect a wide variety of terminals, printers, and computers to each port. and
1
configure the UPS as the
equipment using the appropriate parameters for the mode you select. The following
section provides more information about configuration.
I
The cables you use for connection depend on the equipment you are connecting to the
UPS. Cables should be no longer than -m (SO fl). The connectors for Port 1 and Port 2
on the customer interface panel in the UPS are female, so the cables should be male.
I
Figure 2 shows the pin assignments for Port
page 5 shows the pin assignments for Port
I
1
1
I
1
I
I
4
PORT 1 (DE-g)
NOT USED
RETURN
Plus 80 UPS Communications
i