Configuring The Serial Ports; Figure 7-5. Setup Serial Port 1 Screen - Powerware 9315 UPS Operation Manual

Communication

7.5 Configuring the Serial Ports

You must configure the port for communication using the LCD screen and buttons on the
UPS Monitor Panel.
Select Port 1 from the Setup menu to display one of the Setup Port screens. The screens
for Port 1 and Port 2 are identical, and allow you to specify settings for the two serial
communication ports. Figure 7-5 shows the Setup Serial Port 1 screen.
NOTE You should configure only Port 1 unless field service has performed a wiring
change for Port 2.
UPS System Normal
Alarm:
Notice: None
Battery
Percent
Setup
Port 1
Port 2
Time
Meters
A small return arrow (
arrow is a reminder that you can press the
buttons between the menu box and the information area.
If the scroll bar is in the menu box, press the
area. The first setting (Mode) is highlighted. Press the
to the setting you want to change. To scroll through the available options for that setting,
press the
To save the settings upon exit from this screen, be sure the Save field is set to YES.
7−6
EATON Powerware
Uninterruptible Power System
None
100%
Mode
TERMINAL
Events Statistics Graphics

Figure 7-5. Setup Serial Port 1 Screen

) appears in the upper right corner of the Setup Port screen. This
or button.
9315 UPS (200–300 kVA) Operation Manual S 164201036 Rev G www.powerware.com
®
03 NOV 1997
Setup Serial Port 1
Rate Data/Stop Handshaking
9600 8 1 XON / XOFF
Setup
button on the Monitor Panel to toggle the
button to toggle to the information
or button to move the highlight
14:23:45
Save
NO