To Place The Ups In Normal Mode - Powerware Plus 80 Operation

l
The Control Panel contains these controls:
l
I
I
I
I
l
I
l
I
l
l
I
The following sections describe how you can operate these
change me operating mode of the UPS.
I
To alace the UPS in Normal mode:
I
1. Move me CR1 switch to ON
I
3. Turn me Hoda switch to NORMAL
I
4 . BesurethePawarORReaatbuttonispreasedin.
I
I
The Mode switch is a two-position rotary
the UPS to and from Bypass mode. You oan use this switch to:
mode, and if the bypass source is within acceptable limits. if the
transfer does not occur within 2 seconds, an atarm sounds. You cannot
silence this elarm until the transfer is complete. or until you switch the
Mode switch back to Normal.
The Battery switch is a twc-position
enable or disable the battery contactor.
The Clrcult Breaker (CSl) switch controls the operation of the recthier and
inverter. If CSl is on (closed), the rectifier turns on when the
activated and the proper voltage is at the input terminals..
The Power Off Reset is described in 'Resetting the Power
page 51..
The keyawftch activates the power controls
operation is similar to that of an automobile
operator controls, you turn the keyswitch
the controls. When you release it. it returns to the upright positton.
The rectifier turns on. men the imwrter turns on. when the inveder reaches full voltage.
it turns on and supplies power to the
UPS to achieve Normal
immediately supplied by me bypass source in Sypeas mode until the inverter turns on
and the UPS transfers to Normal mode. The status
indicate when the UPS is in Sypass mods and Norrnat mode.
rotary switch that allows you to manually
on the Control Panel. The
After setting the
to the right momentarily to activate
to start. stop, or
on the Monitor Per'tef
Plus So UPS operator's Manual
on