Data/Stop; Handshaking; Disabled (No Handshaking); Save - Powerware Plus 80 Operation

The data size and stop bits of the equipment connected to this port. These settings
determine the number of bits transmitted per ASCII character. The data size and stop bii
you specify depend on the configuration of your equipment.
For Port 1, the data size must be set to 8, with I or 2 stop bits.
bits/l stop bit and 7 data bits.12 stop bits are available for Port 2.
NOTE: When connecting a computer running a terminal emulation program, you
should set your equipment

Handshaking

This setting controls handshaking. You can

Disabled (No Handshaking)

If handshaking is disabled. the UPS will transmit and receive data via the serial port.
ignoring all inputs from handshaking lines.
If handshaking is enabled, the UPS uses special characters
with the host terminal. The Xon character is defined to be ASCII value 11 hex, and the
character is defined to be ASCII value i 3 hex. On reception of an Xoff command, the UPS
halts transmission until an Xon command is received. In the same way,
receives an Xoff command, the UPS expects me terminal to halt transmission until the UPS
sends an Xon command.

Save

Set to YES to save any changes to configuration settings upon exit from the setup screen.
Set to NO if you do not want to save any changes.
Default Settings
These are the default configuration settings for the serial communications ports:
Port 1 Remote Monitor
Port 2
Terminal
to NO
300 baud
Handshaking Disabled
9800 baud
Handshaking Disabled
Settings of 7 data
Plus 80 UPS Communications