Configuring The Serial Ports; Figure 26. Setup Serial Port 1 Screen - Powerware 9315 Operation Manual

Configuring the Serial Ports

You must configure the port for communications using the LCD screen and
pushbuttons on the UPS Monitor Panel.
Select Port 1 or Port 2 from the Setup menu to display one of the Setup Port
screens. The screens for Port 1 and Port 2 are identical, and allow you to specify
settings for the two serial communication ports. Figure 26 shows the Setup Serial
Port 1 screen.
UPS System Normal
Alarm:
Notice: None
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters
A small return arrow (
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area.
If the scroll bar is in the menu box, press the
information area. The first setting (Mode) is highlighted. Press the
pushbutton to move the highlight to the setting you want to change. To scroll
through the available options for that setting, press the
To save the settings upon exit from this screen, be sure the Save field is set to YES.
Powerware 9315 (200 kVA ---300 kVA) Operation
164201036 Rev. D 041500
Uninterruptible Power System
None
Mode
TERMINAL
Events Statistics Graphics

Figure 26. Setup Serial Port 1 Screen

) appears in the upper right corner of the Setup Port
03 JAN 1997
Setup Serial Port 1
Rate Data/Stop Handshaking
9600 8 1 XON / XOFF
Setup
pushbutton to toggle to the
or
14:23:45
Save
NO
pushbutton on the
or
pushbutton.
43