Object Number, Error Codes - Siemens SIRIUS M200D Manual

A.1.2

Object number, error codes

Object number
The object number is used for unique identification of all the information available in the
motor starter (parameters, control commands, diagnostics, commands, etc.).
The object number is returned in the case of the logbook data records. The object number
uniquely identifies the meaning. It is located in the left-hand column of the data set tables.
Coordination
Coordination is an identifier in the data record header that identifies the "sender" of the data
record.
Error codes with negative data set acknowledgment
Description
If a data set is rejected, an error code is sent with the negative acknowledgment, both via the
device interface and via the bus interface. This provides information about the reason for the
negative acknowledgment.
The error codes comply with the PROFIBUS-DPV1 standard in as far as it applies to the
motor starter.
Evaluation via local device interface with Motor Starter ES
The error codes are evaluated by the Motor Starter ES parameterization and diagnostics
software and output in plaintext.
More information on this can be found in the online help of Motor Starter ES.
Evaluation via PROFIBUS DP
The error codes are output via PROFIBUS DP Layer 2.
More information can be found in the relevant manuals for the PROFIBUS DP protocol
description.
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
Appendix
A.1 Data formats and data sets
191