Siemens SIRIUS M200D Manual page 86

Functions
3.21 PROFIenergy
t
off
t
off_min
t
on
t
Pause_min
86
Time_to_Pause
Time_min_length_of_stay
Time_to_operate
Time_min_Pause
Time the starter requires in order to change to power saving
mode. This time is always 100 ms for M200D. A
parameterized running down time is added to this in the
case of a soft starter (if available and if the starter was in the
ON state):
t = 100 ms + running down time
off
If the soft starter was already off before the pause, pause
mode will be switched to after 100 ms only.
Minimum time that the device spends or should spend in
saving mode.
For M200D: 0 ms
Time that will elapse before the starter changes back to the
operating state. Since the process image is evaluated again
immediately when the M200D exits power saving mode, this
time is 0 ms.
Time that is compared with t
with the "Start_Pause" command to the motor starter);
if t ≥ t , the device switches to saving mode.
Pause Pause_min
Manual, 08/2014, A5E01577426A/RS-AA/004
(is transferred together
Pause
M200D PROFIBUS/PROFINET