Siemens SIRIUS M200D Manual page 117

Auxiliary voltage connection (7/8")
Pin (infeed)
Connecting M12 and 7/8" cable connectors
Note
The current of the 7/8" connectors must not exceed 7 A!
1. Plug the M12 and 7/8" cable connectors into the corresponding circular socket
connectors on the M200D PROFINET communication module. Ensure that the locking
mechanism between the connector and socket is properly applied.
2. Secure the connectors by tightening the knurled ring nut.
NOTICE
It is not permissible to remove the 7/8" cable connectors while M200D PROFINET is in
operation! Always switch off the 24 V-NS DC electronic/encoder supply and the 24 V-S DC
load voltage supply before you remove or insert the 7/8" cable connector.
Note
Removal of the 7/8" cable connector interrupts the supply to downstream modules.
Note
Closing unused sockets
Always seal all unused sockets using M12 and 7/8" caps in order to achieve degree of
protection IP65.
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
Socket (routing) Pin Assignment
1 Switched 0 V (24 V-S DC (-))
2 Unswitched 0 V (24 V-NS DC (-))
3 —
4 Unswitched + 24 V (24 V-NS DC (+))
5 Switched + 24 V (DC 24V-S (+))
Mounting / connection
4.2 Connection
117