Siemens SIRIUS M200D Manual page 130

Configuration / parameterization
5.2 Parameterize
Device parameter
Input 1 signal
Input 2 signal
Input 3 signal
Input 4 signal
Output level 1
Output level 2
Output 1 signal
Output 2 signal
Output 1 action
130
Default setting
Non-retentive
Not inverted
Continuous signal
Control source PIO DO 1.0
Setting range
Retentive
•
Non-retentive
•
Not inverted
•
Inverted
•
Continuous signal
•
Flashing
•
Triggering by means of external control
source
Control source PIO DO 1.0
•
(output 1)
Control source PIO DO 1.1
•
(output 2)
Control source PIO DO 0.2
•
(brake output)
Control source input 1
•
Control source input 2
•
Control source input 3
•
Control source input 4
•
Actuation by motor starter
Run-up
•
Operation/shunting
•
Coasting down
•
On time motor (RUN)
•
Control command motor ON
•
Brake output
•
Device ON
•
Actuation by messages from the motor
starter
Group prewarning
•
Group warning
•
Group fault
•
Bus error
•
Device error
•
Maintenance required
•
Maintenance requested
•
Ready for motor ON
•
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004