Message Output - Siemens SIRIUS M200D Manual

Functions
3.10 Communication over PROFIBUS/PROFINET
3.10.4

Message output

General messages
Ready (automatic)
Group fault
Group warning
Group prewarning
Process image error
Fieldbus interface
Bus error
CPU/Master STOP
Acknowledgment
Trip reset executed
Trip reset not possible
Mode monitoring
Automatic mode
Manual bus mode
Manual local mode
Connection abort in manual mode
Parameter assignment
Parameter assignment active
Invalid parameter value
Parameters cannot be changed in ON state
Parameter number error
Parameters disabled CPU/master active
No external startup parameters received
Statistical data
Maximum pointer deleted
Message bits that can be deleted with trip reset
1)
70
Message
1)
1)
1)
Device can be activated via the BUS (e.g. PLC).
At least one fault is set.
At least one warning is present.
At least one pre-warning is present.
The process image of the outputs contains an illegal
bit combination, e.g. motor CW and motor CCW set
simultaneously.
Fieldbus interface threshold monitoring expired.
PLC program is no longer processed.
Trip reset accepted; that is, error/fault has been
acknowledged.
Fault could not be acknowledged since the cause of
the tripping is still pending.
Automatic (PLC controls)
Manual mode via fieldbus (HMI controls)
Manual local mode:
Manual mode via Motor Starter ES
•
HMI controls
•
Input controls
•
During manual mode, the relevant communication
connection was interrupted for more than 5 seconds.
Yes/No
Parameter not correct
Attempt to change parameters while motor is is
1)
running not permissible.
Specifies the first unaccepted parameter (object
number of the parameter).
Motor starter ignores parameters from the PLC but
informs the PLC that the parameters are in order.
No new parameters have been received from the
PLC after Power ON or restart of the motor starter.
Preventive diagnosis statistical data has been reset.
Manual, 08/2014, A5E01577426A/RS-AA/004
Meaning
M200D PROFIBUS/PROFINET