Configuring - Siemens SIRIUS M200D Manual

Configuration / parameterization
5.1

Configuring

Introduction
Configuration involves configuring and assigning parameters to the motor starters.
Configuration: Systematic arrangement of individual motor starters (configuration).
Parameterization: Definition of parameters using the configuration software.
The M200D motor starters can be parameterized, and they allow access to extensive
diagnostics and statistics data. The PC configuring tool "Motor Starter ES" is optionally
available for this purpose.
A connection to the motor starter can be established in the following ways:
● PROFIBUS DP bus interface
– DPV0/DPV1 master with GSD (also for operation behind Y-link)
– DPV0/DPV1-S7 master with M200D IP65-HSP (STEP 7 HSP) or Motor Starter ES
● PROFINET IO bus interface
– PROFINET controller with GSDML
– PROFINET-S7 controller with M200D IP65-HSP (STEP 7 HSP) or Motor Starter ES
● Locally or via the device interface with Motor Starter ES
The motor starter is configured/parameterized at start-up via PROFIBUS DP/PROFINET IO
by data set start-up.
Parameters can be modified during operation via the bus or the device interface (Motor
Starter ES).
Note
If parameters are modified during operation, they will be overwritten by the configured values
during a restart. If this is not desired, a command must be issued to disable
parameterization.
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
5
119