Master EC100 Owner's Manual page 77

STEP 3: Console and Beauty Covers

Plug the computer cable (30-15) and hand pulse cables (35 x 2) into the corresponding
connectors on the back of the console (30). Mount the console on the mast with four M5 x
12mm screws (78).
 Install the four swing arm pivot point covers (57, 58 left & 59, 60 right) with six 3.5mm x
12mm screws (113).
 Install the four covers (53x2 & 54x2) to the ends of the pedal arms with four M5 x 12mm
screws (78). These covers can be installed upside down!! There is an arrow on the
inside of each cover to indicate correct installation direction.
 Install the four covers (55 & 56, 2 pcs each) at the connection point at the bottom of the
swing arms using four 3.5mm x 12mm screws (113) and four M5 x 12mm screws (78).
Install the front stabilizer cover (47) with two M5 x 12mm screws (78).
77
EN