Master EC100 Owner's Manual page 73

Assembly Instructions
STEP 1: Rear Rail and Pedal Arm Assembly
 Slide the rail assembly (2) under the rear oval stabilizer tube of the main body. Bolt the two
together with two 3/8" x 2-1/4" bolts (106) and 3/8" washers (109) from the top of the tube,
and four 3/8" x 3-3/4" bolts (107) and 3/8" curved washers (108) through the front of the
oval stabilizer. Make sure all six bolts are tightened very securely.
 Attach the two footpads (48 left & 49 right) to the pedal mounting plates with eight M5 x
10mm screws (110).
 Assemble the pedal arm assemblies (5 & 6) to the crank axles of the main body. The
bearings in the pedal arms should slide onto the axles, do not force them because damage
to the bearings can occur. The pedal arms have been previously assembled at the factory
to assure the correct fit. Secure the pedal arms with two 5/16" x 15mm bolts (97) and 5/16"
washers (87).
 Install the two covers (45 right, 46 left) over the pedal arm connection at the axle with two
M6 x 15mm screws (103). Install the two wheel covers (50) with four M5 x 12mm screws
(78).
 Install the four mounting brackets (17) and (26) to the rails with four 5/16" x 3/4" bolts (76).
Install the two steel covers (15 right & 16 left) by lifting the pedal arms so the wheels are off
the tracks then slide the pedal arms, wheels first, through the opening of the steel cover.
Align the cover with the mounting brackets and secure them with eight M5 x 12 mm screws
(78). Install the four small covers (2 x #19 & 2 x #20) with ten M5 x 12mm screws (78).

Install the center aluminium step rail (72) with two 3/8" x 3-3/4" bolts (107) and curved
washers (108) at the rear and two 3/8" x 2-1/4" bolts (106) and flat washers (109) at the
front. Install the two stabilizer tube covers (64 left & 65 right) with two M5 x 12mm screws
(78).
73
EN