Master EC100 Owner's Manual page 75

STEP 2: Console Mast and Swing Arms
 Unravel the computer cable (30-15) and snake it through the bottom of the console mast
(12) and out the top. To install mast tube (12), first insert three M8x25mm screws (75)
onto the mainframe then locate the mast tube (12) on its position and tighten three
screws. Now the last M8x25mm screw (75) must be with 5/16" flat washer (88) to
tighten to the screw hole.
 Mount the console mast covers (61 left & 62 right) and secure with four 3.5mm x 12mm
screws (113).
 Install two wave washers (90) onto the console mast axle then Install the swing arms (10
left & 11 right) onto the axles. Do not force them or use a hammer as damage to the
bearings can occur. The swing arms have been previously assembled at the factory to
assure the correct fit. Secure the arms with two 3/8" x 3/4" bolts (117) and 3/8" flat washers
(120). Attach the bottom of the swing arms to the rod ends of the pedal arms using two
M10 x 38mm shoulder bolts (119) and M10 nylon nuts (118).
75
EN