Replacing A Front Disk Drive - IBM 9006-22P Servicing
Hide thumbs
Also See for 9006-22P:
- Installing and configuring (148 pages) ,
- Problem analysis, system parts, and locations (134 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Figure 4. Removing the 2.5-inch drive from the tray
7. If you are removing more than one drive, repeat the steps in this procedure until all drives are
removed.
Replacing a front disk drive in the 9006-22P system
To replace a front disk drive in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Install a drive into the tray.
Orient the drive such that the connectors are pointing to the rear of the drive.
• A 3.5-inch drive fills the tray, as shown in Figure 5 on page 8. Fasten the drive to the sides of
the tray with the screws (two or three screws on each side), depending on the number of threaded
holes present on the drive. If the number of threaded holes is greater than the number of screws
that are available, use the threaded holes that are closest to each end of the drive.
Removing and replacing parts in the 9006-22P 7
Advertisement
Table of Contents
