Xerox WorkCentre 7132 Service Documentation page 1504

Chain-Link Name
012-081 Eject Motor FORWARD ON/OFF
012-082 Eject Motor REVERSE ON/OFF
012-083 Eject Clamp Low DOWN
012-084 Eject Clamp Middle DOWN
012-085 Eject Clamp UP
012-086 Set Clamp Paddle Solenoid ON
042-001 Main Motor ON (Normal Speed)
042-002 Main Motor ON (Half Speed)
042-003 Auger Motor
042-004 Developer Motor
042-005 Fuser Fan
042-006 Rear Fan
047-001 OFFSET MOTOR1 FORWARD ROTA-
TION
047-003 OFFSET MOTOR2 FORWARD ROTA-
TION
047-004 OFFSET MOTOR2 REVERSE ROTA-
TION
Reversion 4.0
WorkCentre 7132
Table 2 Output Component Control Codes IOT
Connector
Level Meaning
- Same as Name
- Same as Name
- Same as Name
- Same as Name
- Same as Name
L Same as Name
L Main motor rotation at normal pro-
cess speed.
[I/O] Main Motor
[I/O] Main Motor Gain1
[I/O] Main Motor Gain2
[I/O] Main Motor Clock
(normal process speed is determined
depending on combination on Main
Motor Gain 1, Main Motor Gain 2,
and Main Motor Clock).
L Main motor rotation speed at half
process speed.
[I/O] Main Motor
[I/O] Main Motor Gain1
[I/O] Main Motor Gain2
[I/O] Main Motor Clock
(half process speed is determined
depending on combination o Main
Motor Gain 1, Main Motor Gain 2,
and Main Motor Clock).
L Auger motor rotation
[I/O] Auger Motor
[I/O] Auger Motor CLK
L Developer motor rotation
[I/O] Deve Motor
[I/O] Deve Motor CLK
L Fuser fan rotation
Fuser fan rotates at high speed per
start command.
Fuser fan rotates at low speed per
stop command
L Rear fan rotation
- Same as Name
- Same as Name
- Same as Name
January 2007
6-181
Timer Off Cycle Operation Remarks
X X
X X
X X
X X
X X
X X
- X
- X
- X
- X
- X
- X
X X EXIT
X X EXIT
X X EXIT
General procedures information
Component Control