Xerox WorkCentre 7132 Service Documentation page 1501

Stacking Component Codes
NOTE: Some components cannot be energized at the same time as another component. If you
activate such a combination of components, the first component switched on will be automati-
cally switched off.
1. When perform multiple component checking. input new Chain-Link number after one (or
several) component(s) is (are) in operating.
NOTE: Only latest Chain-Link number indicates.
Chain-Link Name
012-110 Registration Clutch ON
012-111 IOT Exit Sensor
012-150 Compile Exit Sensor
012-151 Compile Tray No Paper Sensor
012-190 H-Transport Ent. Sensor
012-191 H-Transport Exit Sensor
012-220 Front Tamper Home Sensor
012-221 Rear Tamper Home Sensor
012-240 Stapler Move Home Sensor
012-241 Stapler Move Position Sensor
012-242 Low Staple Sensor
012-243 Self Priming Sensor
012-244 Staple Home Sensor
012-250 Eject Clamp Home Sensor
012-251 Set Clamp Home Sensor
012-260 Upper Limit Sensor
012-262 Stacker No Paper Sensor
012-267 Stacker Height Sensor
012-268 Stacker Stock A Sensor
012-269 Stacker Stock B Sensor
012-280 Compiler Cover Safety Switch
012-301 Top Cover Switch
012-302 Finisher Front Cover Switch
012-303 H-Transport Interlock Sensor
042-200 Belt Home Position Sensor
047-200 FACE UP TRAY DETECTED
047-201 OCT2 DETECTED
047-205 OCT1 HOME POSITION SENSOR
047-206 OCT2 HOME POSITION SENSOR
061-200 Polygon Motor Lock
061-201 ROS Motor Fan
General procedures information
Component Control
Table 1 Input Component Control Codes IOT
Connector
Level Meaning
H IOT Regi Clutch ON
H with paper
H with paper
H with paper
H with paper
H with paper
H other than home position
H other than home position
H other than home position
H other than home position
H without pin
H Not Ready
H other than home position
H other than home position
H other than home position
H upper limit position
H without finisher
H With Paper
H Cover Position
H Cover Position
H Compiler Upper Chute Open
H Top Cover is closed
H Finisher Front Cover is closed
H H-Transport is closed
L Same as Name
L Detected
L Detected
L OCT1 is at its home position
L OCT2 is at its home position
L PLYGON_MOT_LOCK signal is displayed.
H ROS_FAN_FAIL signal is displayed.
January 2007
6-178
2. When confirm the status of another component still in progress, select Enter Number then
input Chain-Link number of applicable component.
3. Select Stop key after confirming.
Stop operation of component indicated on screen.
NOTE: There are no Cyclic Component in below category:
• IIT Input Component.
• IIT Output Component.
• IOT Input Component.
Remarks
-
EXIT
EXIT
EXIT
EXIT
Reversion 4.0
WorkCentre 7132