Xerox WorkCentre 7132 Service Documentation page 1477

Chain-Link NVM Name
825-079 Call Restriction for Ch2
825-080 Call Restriction for Ch3
825-081 Call Restriction for Ch4
825-082 Call Restriction for Ch5
825-103 RX Gain in G3 Communication Mode
825-104 TX Gain in ISDN G3 Communication Mode 0~15
825-115 PB Pause Time. PB (DTMF) Dial Inter-digit
Pause Time.
825-127 Attenuates analog transmission to attenu-
ated Transmission Analog Output by
modem for Channel 0.
825-128 Attenuates analog transmission to attenu-
ated Transmission Analog Output by
modem for Channel 1.
825-129 Attenuates analog transmission to attenu-
ated Transmission Analog Output by
modem for Channel 2.
825-130 Attenuates analog transmission to attenu-
ated Transmission Analog Output by
modem for Channel 3.
825-131 Attenuates analog transmission to attenu-
ated Transmission Analog Output by
modem for Channel 4.
825-132 Attenuates analog transmission to attenu-
ated Transmission Analog Output by
modem for Channel 5.
825-133 Busy Tone detection (On/Off) setting
825-134 Dial Tone detection (On/Off) setting
825-158 No. of sheets transmitted in the transmis-
sion result report (Cannot be changed
because of ROM data)
825-159 ECM Capability (Auto Error Resending fea-
ture): A feature that starts resending auto-
matically when an error that occurred
during transmission has been repaired.
825-160 Time before the CNG Signal starts to be
sent. Time that has elapsed after dialing
has completed and when the initial CNG
signal starts to be sent
General procedures information
Controller & Fax NVM List
Table 11 NVM 825 FAX Service
Setup
Range Initial Value Read/Write
0~1 0: Outgoing/Incom- Read/Write
ing Call
0~1 0: Outgoing/Incom- Read/Write
ing Call
0~1 0: Outgoing/Incom- Read/Write
ing Call
0~1 0: Outgoing/Incom- Read/Write
ing Call
0~15 6 (-6dB) Read/Write
0 Read/Write
0~255 102 Read/Write
8~15 8: 8dBm Read/Write
8~15 8: 8dBm Read/Write
8~15 8: 8dBm Read/Write
8~15 15: 15dBm Read/Write
8~15 8: 8dBm Read/Write
8~15 15: 15dBm Read/Write
0~1 1: Detect Busy Tone Read/Write
0~1 0: Do not detect dial Read/Write
tone
0~1 0 Read/Write
0~1 1: Enable Read/Write
20~140 60: 3000ms Read/Write
January 2007
6-154
Description
0: Outgoing/Incoming Call, 1: Outgoing Call only
0: Outgoing/Incoming Call, 1: Outgoing Call only
0: Outgoing/Incoming Call, 1: Outgoing Call only
0: Outgoing/Incoming Call, 1: Outgoing Call only
0~-15dB
0~-15dB
0~255 (ms)
8: 8dBm~15: 15dBm, step: -1dBm
8: 8dBm~15: 15dBm, step: -1dBm
8: 8dBm~15: 15dBm, step: -1dBm
8: 8dBm~15: 15dBm, step: -1dBm
8: 8dBm~15: 15dBm, step: -1dBm
8: 8dBm~15: 15dBm, step: -1dBm
0: Do not detect Busy Tone, 1: Detect Busy Tone
0: Do not detect dial tone, 1: Detect dial tone
0: Total No. of sheets for resending in the same transmission 1:
Total No. of sheets for each connection
0: Disable, 1: Enable
20: 1 second~140: 7 seconds, 1: 50msec
Reversion 4.0
WorkCentre 7132