Xerox WorkCentre 7132 Service Documentation page 1478

Chain-Link NVM Name
825-161 CED Send Frequency: CED signal fre-
quency.
825-162 T1 Timer Value at Receive mode
825-163 Timer Value of no tone timing recom-
mended in T.30
825-164 FSK detection before image information is
received (To be referred to at Non-ECM)
825-165 FSK detection before image information is
received
825-166 G3M CSI Send CSI: Notification signal to
the Sender of the ID Code registered at the
Receiver.
825-168 Sending of Local Name
825-169 To determine resending of the Local Name 0~1
825-170 ECM Frame Size (The frame is configured
from the pixels which are divided into 8 bits
for every 1mm)
825-171 G3M ECM T5 Timer (2 channel common)
Timer to the RNR Signal sent out when
memory overflow etc. occurs at the
Receiver, or when continuous receiving is
not possible.
825-173 Send Reference of RTN Command (Pro-
portion) RTN: The message is not received
properly, indicating that Training is neces-
sary.
825-174 Send Reference of RTN Command (No. of
Continuous Lines)
825-175 No. of bytes of the DIS/DTC FIF Sending
(DTC: Send command in response to DIS)
825-176 ECM Capability (Auto Error Resending fea-
ture): A feature to start resending when an
error has been repaired during transmis-
sion. (For International communication)
825-177 CCITT Trellis Capability On/Off and types
825-178 CCITT Trellis Capability On/Off and types
(Used in International Communication)
825-179 Ch0 ECM Block Synchronize
825-180 ECM Block Synchronize for Ch1
825-181 ECM Block Synchronize for Ch2
825-182 ECM Block Synchronize for Ch3
825-183 ECM Block Synchronize for Ch4
825-184 ECM Block Synchronize for Ch5
Reversion 4.0
WorkCentre 7132
Table 11 NVM 825 FAX Service
Setup
Range Initial Value Read/Write
0~1 1: 2100Hz Read/Write
1~90 39sec Read/Write
0~1 0: 75msec Read/Write
0~1 1: Detect Read/Write
0~1 0: Do not detect Read/Write
0~1 0: Transmit Read/Write
0~1 1: ON Read/Write
0: Do not resend Read/Write
0~1 0: 256bytes Read/Write
0~2 0: 1 (min) Read/Write
0~3 0: 5% Read/Write
0~3 2: 6line, Read/Write
0~1 0: No limit Read/Write
0~1 1: Enable Read/Write
0~2 2: V.17 or later Read/Write
0~2 2: V.17 or later Read/Write
0~2 0: 200ms Read/Write
0~2 0: 200ms Read/Write
0~2 0: 200ms Read/Write
0~2 0: 200ms Read/Write
0~2 0: 200ms Read/Write
0~2 0: 200ms Read/Write
January 2007
6-155
Description
0: 1080Hz, 1: 2100Hz
1~90 (sec)
0: 75msec, 1sec
0: Do not detect, 1: Detect
0: Do not detect, 1: Detect
0: Transmit, 1: OFF
0: OFF, 1: ON
0: Do not resend, 1: Resend
0: 256 bytes, 1: 64 bytes
0: 1 (min), 1: 3 (min), 2: No limit
0: 5%, 1: 10%, 2: 15%, 3: 20%
0: No limit, 1: 3line, 2: 6line, 3: 12line
0: No limit, 1: 4bytes System
0: Disable, 1: Enable
0: V.27 or later, 1: V.29 or later, 2: V.17 or later
0: V.27 or later, 1: V.29 or later, 2: V.17 or later
0: 200 ms, 1: 500 ms, 2: 1 sec
0: 200 ms, 1: 500 ms, 2: 1 sec,
0: 200 ms, 1: 500 ms, 2: 1 sec,
0: 200 ms, 1: 500 ms, 2: 1 sec,
0: 200 ms, 1: 500 ms, 2: 1 sec
0: 200 ms, 1: 500 ms, 2: 1 sec,
General procedures information
Controller & Fax NVM List