Siemens SINAMICS S120 Manual page 70

Electrical installation
4.2 Electrical installation: Checklist
Item Activity
Options
22 G20,
CBC10 Communication
Board
23 G33,
CBE20 Communication
Board
24 G51 to G54,
Temperature sensor
module TM150
25 K01 to K05,
Safety license for 1 to 5
axes
26 K46,
SMC10 Sensor Module
27 K48,
SMC20 Sensor Module
68
The supplied CBC10 is installed in the factory in the option
slot of the Control Unit.
(→ See the Chapter titled "Options", in section "G20,
CBC10 Communication Board")
The supplied CBE20 is installed in the factory in the option
slot of the Control Unit.
Remove the CBE20 in a no-current state and note down
the MAC address. Install the CBE20 into the option slot
again.
(→ See the chapter titled "Options", section "G33, CBE20
Communication Board")
The Terminal Module TM150 can be connected to a
maximum of 12 temperature sensors (PT100, PT1000,
KTY84, PTC, bimetallic NC contact).
(→ See section "Options" in Section "G51 to G54,
temperature sensor module TM150 ")
Activating the safety licenses.
(→ See Chapter "Options" in Section "K01 to K05, Safety
license for 1 to 5 axes")
The SMC10 Sensor Module is used for detecting the
actual motor speed and the rotor position angle.
The following encoders are supported by the SMC10
Sensor Module:
Resolver, 2-pin

Resolver, multi-pole

(→ See the chapter titled "Options", section "K46, SMC10
Sensor Module for detecting the actual motor speed and
the rotor position angle")
The SMC20 Sensor Module is used for detecting the
actual motor speed and the path length.
The following encoders are supported by the SMC20
Sensor Module:
Incremental sin/cos 1Vpp

EnDat absolute encoder

SSI encoder

(→ See the chapter titled "Options", section "K48, SMC20
Sensor Module for detecting the actual motor speed and
the path length")
Applicable?/Completed?
Cabinet Modules
Manual, 03/2013, A5E03263538A