Electrical installation
4.6 Connections
Cable routing for DRIVE-CLiQ connections and signal cables, frame sizes HX+HI and JX+JI
1. Feed the cable for the DRIVE-CLiQ/signal cables into the cabinet from the bottom left.
2. Use cable ties to secure the cable at suitable points.
3. Feed the cable up through the cabinet and, when it reaches the Control Unit, guide it up
4. Use cable ties to secure the cable at suitable points.
5. Connect DRIVE-CLiQ or signal cable to the Control Unit.
124
HX+HI
and to the right towards the Control Unit. When doing so, route the cable in a similar
manner to the standard cables that have already been installed in the cabinet.
Frame size:
JX+JI
Cabinet Modules
Manual, 03/2013, A5E03263538A