Table of Contents
Advertisement
CHAPTER 3
Unpacking and Inspecting the Gateway
Unpacking the Gateway
Inspecting the Gateway Components and Accessories
Copyright © 2011, Juniper Networks, Inc.
After you have prepared the installation site for the BX7000 Multi-Access Gateway, you can
unpack and install the gateway.
This chapter provides information about how to unpack the gateway from the box and how to
inspect the gateway components and other accessories.
This chapter contains the following sections:
Unpacking the Gateway on page 23
Inspecting the Gateway Components and Accessories on page 23
If You Detect or Suspect Damage on page 25
To unpack the gateway, use a utility knife to cut the sealing tape on the shipping carton.
The gateway is shipped in a cardboard box. The box measures 4.72 in. (12 cm) high, 14.17 in.
(36 cm) wide, and 22.83 in. (58 cm) deep. The box weighs 18.07 lb (8.2 Kg). A Getting Started
Guide is also included in each box.
To unpack the gateway:
1.
Open the box cover with a knife.
2.
Remove the chassis, shipping kit, and Getting Started Guide from the box.
3.
Remove the ESD bag that covers the gateway.
4.
Save the box cover and packing materials in case you need to move or ship the gateway later.
The packaging utilizes recyclable materials in the design and should be disposed of properly.
Recycle packaging according to your local, state, or country-specific laws and regulations.
Note: Wear gloves whenever you handle the gateway.
After you remove the components from the cardboard box:
Confirm the parts in the box with the packing list included with the shipment.
Inspect all external surfaces and external connectors for visible signs of damage.
Inspect all parts shipped.
CHAPTER 3: Unpacking and Inspecting the Gateway
Unpacking the Gateway
23
Advertisement
Table of Contents
Troubleshooting
