Table of Contents
Advertisement
CHAPTER 4
Installing the Gateway
Safety Requirements, Warnings, and Guidelines for Installing the Gateway
Before you Begin
Copyright © 2011, Juniper Networks, Inc.
The BX7000 Multi-Access Gateway can be mounted on a wall or in a rack or cabinet. This chapter
describes how to install the gateway. It contains the following sections:
Safety Requirements, Warnings, and Guidelines for Installing the Gateway on page 27
Before you Begin on page 27
Installing the Cable Management brackets on page 28
Wall-Mounted Installation on page 29
Rack-Mounted Installation on page 31
Warning: To avoid harm to yourself or the platform as you install and maintain the gateway,
follow the guidelines for working with and near electrical equipment as well as the safety
procedures for working with networking equipment.
For a discussion on how to make the installation site a safe environment, see Preparing the Site
for Gateway Installation on page 19.
For a list of safety warnings, see Safety and Regulatory Compliance Information on page 79 and
particularly Safety and Regulatory Compliance Information on page 79.
However, providing an exhaustive set of guidelines for working with electrical equipment is beyond
the scope of this guide.
Before installing the gateway, ensure the following:
Verify that you have prepared the installation site as described in "Preparing the Site for
Gateway Installation" on page 19.
Verify that the power supply is not connected to any power source.
Correct the following hazardous conditions: moist or wet floors, leaks, and improper grounding.
Check if you have the necessary tools and accessories to complete the installation.
Note: When mounting the gateway, ensure that it is within the reach of the power outlet.
Safety Requirements, Warnings, and Guidelines for Installing the Gateway
CHAPTER 4: Installing the Gateway
27
Advertisement
Table of Contents
Troubleshooting
