Rj-45 Connector Pinouts For The Bits Interface; Bnc Connector Pinouts; Table 35: Rj-45 Connector Pinouts For Bits Interface - Juniper BX7000 Hardware Manual

:

RJ-45 Connector Pinouts for the BITS Interface

BNC Connector Pinouts

108 RJ-45 Connector Pinouts for the BITS Interface
Table 34: USB Type A Connector Pinouts
Pin
1
2
3
4
The BITS interface on the advanced clocking module is an RJ-45 receptacle that accepts an RJ-45
cable. Table 35 on page 108 lists the pinouts for the RJ-45 connector.

Table 35: RJ-45 Connector Pinouts for BITS Interface

Pin Signal
1 RX Tip
2 RX Ring
3 No Connect
4 No Connect
5 No Connect
6 No Connect
Table 36 on page 108 lists connector pinouts for the BNC connectors.
Table 36: BNC Connector Pinouts
Pin Signal
1 Center/core - Signal
2 Outer/Shield - Shield Ground
3 Shield Ground
4 Shield Ground
5 Shield Ground
Signal
+5
–Data
+Data
GND
Copyright © 2010, Juniper Networks, Inc.