Compliance Statements For Nebs Requirements; Compliance Statements For Emc Requirements; Compliance Statements For Environmental Requirements; Compliance Statement For Acoustic Noise - Juniper BX7000 Hardware Manual

:

Compliance Statements for NEBS Requirements

Compliance Statements for EMC Requirements

Compliance Statements for Environmental Requirements

Compliance Statement for Acoustic Noise

Cabling Recommendations

100 Cabling Recommendations
ACA TS016
Note: Use Category 5e UTP cables for copper Ethernet ports if the installation environment
requires radiated noise immunity <= 3 V/m, conducted noise immunity <= 3 V.
Use Category 5e shielded twisted-pair (STP) cables for copper Ethernet ports if the installation
environment requires radiated noise immunity > 3 V/m, conducted noise immunity > 3 V.
The equipment is suitable for installation as part of the Common Bonding Network (CBN).
The equipment is suitable for installation in locations where the National Electrical Code (NEC)
applies.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Japan
This is a Class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
United States
The gateway has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Lithium Battery
Batteries in this product are not based on mercury, lead, or cadmium substances. The batteries
used in this product are in compliance with EU Directives 91/157/EEC, 93/86/EEC, and 98/101/EEC.
The product documentation includes instructional information on the proper method of
reclamation and recycling.
The emitted sound pressure is 0 dB (acoustic noise) (negligible—only passive cooling is used).
Comply with the following cabling recommendations:
Use shielded or unshielded cable, as required. For more information, see Table 4 on page 10.
Ensure that cable distance and rate limits meet IEEE-recommended maximum speeds and
distances for signaling purposes. For information about attenuation and power loss in optical
fiber cables, see:
ANSI T1.646a-1997 Telecommunications – Broadband ISDN - Physical Layer Specification
for User-Network Interfaces Including DS1/ATM (1997)
ANSI T1.646-1995 Telecommunications – Broadband ISDN - Physical Layer Specification
for User-Network Interfaces Including DS1/ATM (1995)
Copyright © 2010, Juniper Networks, Inc.