Table of Contents
Advertisement
Installing the Advanced Clocking Module
To install an advanced clocking module (see Figure 45 on page 92):
1.
Attach an ESD wrist strap to your bare wrist and connect the wrist strap to one of the ESD
points on the chassis.
2.
Ensure that the gateway is turned off.
3.
Loosen the two M3 size captive screws on the blank faceplate on the front panel using a
number 2 Phillips screwdriver.
4.
Remove the blank faceplate that covers the slot.
5.
Remove the peel-off paper from the thermal pad of the advanced clocking module.
6.
Hold the advanced clocking module horizontally, with the BITS interface and BNC connectors
facing towards you and the connectors facing the chassis slot.
7.
Horizontally align the card with the guides at the right and left of the slot.
8.
Gently push the card into the slot until the card is fully seated.
9.
Tighten the captive screws on the front cover using the number 2 Phillips screwdriver.
10.
Connect the cables to the BNC connector and BITS interface.
Caution: Do not force the card into the slot. Doing so may damage the card or the connector.
Figure 32: Installing the Advanced Clocking Module
CHAPTER 10: Replacing Hardware Components
Replacing the Advanced Clocking Module
69
Advertisement
Table of Contents
Troubleshooting
