Hardware Compliance; Federal Communications Commission (Fcc) Statement; Fcc Requirements For Consumer Products; Food And Drug Administration, Center For Devices, And Radiological Health - Juniper BX7000 Hardware Manual

Hardware Compliance

Federal Communications Commission (FCC) Statement

FCC Requirements for Consumer Products

Food and Drug Administration, Center for Devices, and Radiological Health

Canadian Department of Communications Radio Interference Regulations

Ensure that power cords deliver sufficient power to the system.
Attach laser fiber connectors only to Class 1 laser devices in accordance with IEC 60825-1,
Safety of Laser Products—Part 1.
Route cables so that they do not restrict ventilation or airflow.
Route cables so that the power supplies are easily accessible.
Route cables in a logical direction to prevent loss of connectivity to other equipment in the rack,
associated equipment in adjacent racks, or the backbone network.
Consider using cable-management brackets to keep network cables untangled and orderly and
to prevent cables from hindering access to other slots.
For additional cable recommendations, consult the document GR-63–CORE and GR-1089–CORE:
Network Equipment Building System (NEBS) Requirements: Physical Protection, Issue 2, April
2002.
The gateway meets the hardware compliance requirements in this section.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
This equipment is designed for use with properly shielded and terminated cables. Refer to the
installation sections of this manual before operation.
This equipment complies with FCC rules, ACTA TIA/EIA-IS-968. On the back side of this
equipment is a label that contains, among other information, the FCC Registration Number and
Ringer Equivalence Number (REN) for this equipment. If requested, provide this information to your
telephone company.
If this equipment causes harm to the telephone network, the telephone company may discontinue
your service temporarily. If possible, they will notify you in advance. But if advance notice is not
practical, you will be notified as soon as possible. You will be advised of your right to file a
complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations, or procedures
that could affect the proper operation of your equipment. If they do, you will be given advance
notice so as to give you an opportunity to maintain uninterrupted service.
If you experience trouble with this equipment, please contact Juniper Networks for warranty or
repair information. The telephone company may ask that you disconnect this equipment from the
network until the problem has been corrected or until you are sure that the equipment is not
malfunctioning.
This equipment complies with 21 CFR 1040.10 and 1040.11 for the safe use of lasers.
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
:
Hardware Compliance 101