Making Output Connections; Output Connector Modules; Pinout For The Db9 Output Module - Symmetricom EDGE CLOCK 1000 User Manual

Chapter 3 Installing the TimeProvider
Making Connections

Making Output Connections

You make the output signal connections using one of the Output modules listed in
Table 3-4. Attach the module to the shelf before you connect cables.
Table 3-4. Output Connector Modules
Item Number
090-58091-01
090-58091-02
090-58091-03
090-58091-07
090-58091-04
090-58091-05
090-58091-06
090-58071-02
Installing the Output Module
Attach the Output module to the shelf and secure it using the screws at the top and
bottom of the module.
Table 3-5 lists the pinout for the DB9 four-connector Output module (090-58091-03),
and the DB9 eight-connector Output module (090-58091-07) which are shown in
Figure 3-13.
Table 3-5. Pinout for the DB9 Output Module
4-Connector Output Module
Pin
1
2
4, 5, and 6
8
9
66 TimeProvider User's Guide
Description
BNC Output module
Wire-wrap Output module
DB9 Output module – four connectors
DB9 Output module – eight connectors
SMZ/BT43 Output module
Metric (Siemens) 1.0/2.3 Output module
Metric (Siemens) 1.6/5.6 Output module
Wire-wrap TIA/EIA-B-422 Output module
Description
Port A Tip
Port A Ring
Chassis Ground
Port B Tip
Port B Ring
Figure 3-12
Figure 3-12
Figure 3-13
Figure 3-13
Figure 3-14
Figure 3-14
Figure 3-14
Figure 3-15
8-Connector Output Module
Pin
1 Chassis Ground
2 Tip (or Ring)
6 Ring (or Tip)
3, 4, 5 Not used
7, 8, 9 Not used
097-58001-02 Revision G – April 2008
Reference
Description