Symmetricom EDGE CLOCK 1000 User Manual page 128

Chapter 4 Provisioning the TimeProvider
Provisioning Alarms
Table 4-3. Alarm Conditions and Defaults (Continued)
Description of Alarm
Alarm ID
Condition
CLKWARM Local oscillator on the
specified IOC is in
Warm-up mode
CLKFREE Local oscillator on
specified IOC is in
Free-run mode
CLKBRDG Local oscillator on
specified IOC is in
Bridging mode
CLKHOLD Local oscillator on
specified IOC is in
Holdover mode
INPDISQ Specified input has
been disqualified or
qualified as a possible
system reference.
INPLOS Specified input has
Loss Of Signal.
INPFRQ Specified input has
calculated received
frequency that exceeds
the pull-in range of the
LO.This alarm condition
disqualifies the input as
a possible reference.
INPPHASE Specified input port's
phase measurement
exceeds usable value.
EXDSC Input has had excessive
discontinuities, indicated
by more than 3 signal
faults (OOF, BPV, CRC,
or AIS) within a 5-minute
window. The alarm
clears when the
5-minute window
contains less than 3
signal faults.
128 TimeProvider User's Guide
Possible
Alarm
Levels
MN | MJ IMMED
MN | MJ | IMMED
CR
MN | MJ | IMMED
CR
MN | MJ | IMMED
CR
<aid> = PRS
MN | MJ | FLT
CR DELAY
MN | MJ | IMMED
1 CR
NR | NA | IMMED
MN | MJ |
CR
2
NR | NA | IMMED
MN | MJ |
CR
NR | NA | IMMED
MN | MJ |
CR
Error Error
Delay Delay
Default Editable?
No
No
No
No
Yes
No
No
No
No
097-58001-02 Revision G – April 2008
Default Level
SSU SUB
Mode Mode
MN MN
MJ MJ
MJ MJ
MJ MJ
MN MN
MN MN
MN NR
MN MN
MN MN