Logging In For The First Time - Symmetricom EDGE CLOCK 1000 User Manual

Powering Up the TimeProvider
To power up the TimeProvider, perform one of the following tasks, as appropriate:
Connect the power leads from the power supply (see
Connections, on page 61)
Install the fuse in the fuse panel
Turn on the power supply
LED Indications on Power-up
The LEDs on the IMC, IOC, and TPIU (if present) illuminate in the following sequence:
The LEDs on the TPIU remain off until the Master shelf has completed its power-on
testing and the GPS input has been enabled. The TPIU and Antenna Power LEDs
light green and the Antenna Signal LED lights red. When the Master shelf
completes its power-on testing, the Antenna Signal LED lights green, indicating that
the TPIU is receiving a valid signal from the antenna.

Logging In for the First Time

To log in to the TimeProvider for the first time, you must create a username and
password using the TL1 commands described below. Once you create a username
and password, you can connect to the TimeProvider using the SynCraft application
as described in
section.
1. Connect a straight-through DB-9-to-DB-9 serial cable to the local Craft port
located on the front panel of the IMC or IMC/TPIU card. Connect the other end of
the cable to a computer.
2. Start a terminal emulation program such as HyperTerminal or ProComm Plus.
Configure the program for 9600 baud, 8 data bits, No parity, and 1 stop bit, which
are the TimeProvider's default communication parameter values.
3. Type (semicolon). If the TimeProvider responds with a Deny response, you
;
have established communications. If you do not receive the Deny response,
check the connections, the cable, and the program settings.
Changing the Echo Mode
To view the keystrokes you enter in the terminal emulation program, you need to set
the Echo mode to Enable. Issue the following command:
ED-EQPT::COML:TS1000::ECHO=ENABLE;
The TimeProvider responds with:
M
;
097-58001-02 Revision G – April 2008
Using SynCraft, on page 102, or using the TL1 commands in this
TIMEPROVIDER 07-08-24 10:15:04
TS1000 COMPLD
Chapter 4 Provisioning the TimeProvider
Starting the TimeProvider for the First Time
Making Power
TimeProvider User's Guide 89