Symmetricom EDGE CLOCK 1000 User Manual page 168

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
Table 6-5. Event Codes (Continued)
Keyword
Event ID
Description
ECHO The current sessions'
echo setting has
changed
FLOW The IMC serial port
flow control has
changed
FWFAIL Firmware upgrade of
IMC or IOC was not
successful
FWOK Firmware upgrade of
IMC or IOC was
successful
INACTTIME The communication
inactivity timeout has
been set. If no activity
within the specified
time, the session
closes
INITLOG The event log has
been initialized
IPADDR The IMC Ethernet
address has been
changed
IPGATE The IMC Ethernet
gateway address has
been changed
IPSUB The IMC Ethernet
subnet mask has been
changed
ISDIFF Indicates that the CRC
of two Istate images
stored on separate
modules are different
168 TimeProvider User's Guide
AID Default Value/
TYPE Keyword
EQPT DISABLE
EQPT NONE
EQPT n/a
EQPT n/a
EQPT 0
EQPT n/a
EQPT 127.0.0.1
EQPT 127.0.0.1
EQPT 255.255.255.0
EQPT n/a
Description of Values
ENABLE – User's keystrokes
are echoed
DISABLE – User's keystrokes
are not echoed
NONE – No flow control
SW – Software flow control
(XON/XOFF)
HW – Hardware flow control
(CTS/RTS)
SWHW – Both hardware and
software flow control used
n/a
n/a
0 – Disable timeout
100 to 10000 seconds
n/a
1.0.0.1 to 254.255.255.254
1.0.0.1 to 254.255.255.254
n/a
n/a
097-58001-02 Revision G – April 2008