Symmetricom EDGE CLOCK 1000 User Manual page 175

Table 6-6. Set and Clear Conditions for Alarms (Continued)
Alarm ID Set Alarm Conditional Description
BTBCKUP BesTime backup reference disqualified
CLKBRDG Clock entered Bridging mode
CLKFREE Clock entered Free-run mode
CLKHOLD Clock entered Holdover mode
CLKWARM Clock entered Warm-up mode
SYNTHEOR Output generator exceeded pull-in
range
ANTCOMM GPS antenna communication fault
GPSPOS GPS antenna position unknown
GPSPWR GPS power fault
GPSSYS GPS system fault
GPSTRK GPS is not tracking satellites
INPDISQ GPS input is disqualified
INPLOS LOS fault
INPFRQ Frequency threshold exceeded
INPPHASE Phase error exceeded threshold
EXDSC Excessive discontinuity fault
FFOFF FFOFF exceeded threshold
MTIE MTIE exceeded threshold
TPIUSIG TPIU signal fault
INPDISQ Input disqualified as possible reference
INPAIS AIS fault
INPLOS LOS fault
INPOOF OOF fault
INPFRQ Frequency threshold exceeded
INPPHASE Phase error exceeded threshold
INPQL Quality Level (SSM) exceeded
threshold
097-58001-02 Revision G – April 2008
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Clear Alarm Conditional Description
BesTime backup sources qualified
Clock exited Bridging mode
Clock exited Free-run mode
Clock exited Holdover mode
Clock exited Warm-up mode
Output generator within pull-in range
GPS Codes
GPS antenna comm fault cleared
GPS antenna position known
GPS power fault cleared
GPS system OK
GPS is tracking satellites
GPS input is enabled
LOS fault cleared
Frequency within threshold
Phase error within threshold
Excessive discontinuity cleared
FFOFF within threshold
MTIE within threshold
TPIU signal fault cleared
PRS and INP[p] Codes
Input qualified as possible reference
AIS fault cleared
LOS fault cleared
OOF fault cleared
Frequency within threshold
Phase error within threshold
Quality Level (SSM) within threshold
Troubleshooting the TimeProvider
TimeProvider User's Guide 175