Symmetricom EDGE CLOCK 1000 User Manual page 129

Table 4-3. Alarm Conditions and Defaults (Continued)
Description of Alarm
Alarm ID
Condition
INPDISQ Specified input has
been disqualified or
qualified as a possible
system reference.
INPAIS The specified input is
receiving an Alarm
Indication Signal.
INPLOS The specified input has
Loss of Signal.
INPOOF The specified input is
receiving an Out of
Frame signal.
INPFRQ Specified input port's
calculated received
frequency exceeds the
pull-in range of the
LO.This alarm condition
disqualifies the input as
a possible reference.
INPPHASE Specified input port's
phase measurement
exceeds usable value.
INPQL The received SSM is of
lesser quality than the
provisioned QLEVEL for
a specified input. This
alarm occurs when you
provision the input's
QLEVEL below the
quality level of the LO.
EXDSC Input has had excessive
discontinuities, indicated
by more than 3 signal
faults (OOF, BPV, CRC,
or AIS) within a 5-minute
window. The alarm
clears when the 5-
minute window contains
less than 3 signal faults.
097-58001-02 Revision G – April 2008
Possible
Alarm
Levels
<aid> = INP1 or INP2
MN | MJ |
CR
MN | MJ |
CR
1
MN | MJ |
1 CR
MN | MJ |
CR
1
NR | NA |
MN | MJ |
CR
2
NR | NA |
MN | MJ |
CR
NR | NA |
MN | MJ |
CR
NR | NA |
MN | MJ |
CR
Chapter 4 Provisioning the TimeProvider
Error Error
Delay Delay
Default Editable?
FLT Yes
DELAY
IMMED No
IMMED No
IMMED No
IMMED No
IMMED No
IMMED No
IMMED No
TimeProvider User's Guide 129
Provisioning Alarms
Default Level
SSU SUB
Mode Mode
MN MN
MN MN
MN MN
MN MN
MN NR
MN MN
MN MN
MN MN