Symmetricom EDGE CLOCK 1000 User Manual page 190

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Upgrading the Firmware
3. To start the download, issue the command
ACT-SWDL::IMC:TP1000;
The TimeProvider issues an In-Process response, the TL1 connection closes,
and the TimeProvider waits to receive the upgrade software using the Ymodem
protocol.
4. Use a Ymodem file transfer program such as SynCraft to transfer the upgrade
software to the TimeProvider. You must start the transfer within 60 seconds or the
TimeProvider issues a Deny response. The new software is loaded into the IOC,
after which it is rebooted and enters the Warm-up mode for up to 30 minutes.
5. The COMPLD message appears after a successful transfer.
6. Restore the contents of the IOC memory from the IMC by issuing the command:
CPY-MEM:::::IMC,IOC,IOC;
Upgrading Redundant IOCs
To avoid output interruptions, the TimeProvider must be in the following state:
Two installed and communicating IOCs
Both IOCs are in the Locked mode
Both IOCs are In Service
Both IOCs are alarm-free
One IOC is Active
If any of these conditions are not present, then the outputs are interrupted for up to
30 minutes until the upgraded IOC enters the Locked mode.
To upgrade the software in both IOCs, use the following procedure:
1. Log in to the TimeProvider with an Admin- or Security-level user id and
password.
2. Back up the contents of the IOC memory in the IMC by issuing the command:
CPY-MEM:::::IOC,IMC,IOC;
3. Start the download by issuing the command:
ACT-SWDL::IMC;
The TimeProvider issues an In-Process response, the TL1 connection closes,
and the TimeProvider waits to receive the upgrade software using the Ymodem
protocol.
190 TimeProvider User's Guide 097-58001-02 Revision G – April 2008