Symmetricom EDGE CLOCK 1000 User Manual page 171

Table 6-5. Event Codes (Continued)
Keyword
Event ID
Description
RESET The indicated IOC is
being restarted after a
user-requested reset.
All alarms are cleared,
if it was Active, it
becomes Standby
SYSMODE The system mode of
operation has been
changed
CLKFSTLK The local oscillator in
the specified IOC is in
Fast-Lock mode
CLKLOCK The local oscillator in
the specified IOC is in
Lock mode
SCAVAIL The specified IOC is in
SmartClock mode
CRCENA Indicates whether the
E1 (CAS/CCS) inputs
are using CRC4
checking. If the E1
input is provisioned to
read SSMs, then this
value is Enabled
097-58001-02 Revision G – April 2008
Chapter 6 Maintaining and Troubleshooting the TimeProvider
AID Default Value/
TYPE Keyword
EQPT n/a
EQPT SSU
IOC Clock Events
EQPT n/a
EQPT n/a
EQPT OFF
IOC Input Events
T1 DISABLE
Troubleshooting the TimeProvider
Description of Values
n/a
SSU – Sync Supply Unit
mode
SUB – Subtending mode
PRR – Primary Reference
Receiver mode
n/a
n/a
OFF – SmartClock is not
available
ON – SmartClock is available
ENABLE | DISABLE
TimeProvider User's Guide 171