Symmetricom EDGE CLOCK 1000 User Manual page 183

Table 6-7. Alarm Codes (Continued)
Event ID Description
INPQL The received SSM on the
specified input is of lesser
quality than the local oscillator's
QLEVEL.
INPTRR Specified input port has a
Tip/Ring reversal on its
connection to the system.
EXDSC Specified input port has exces-
sive discontinuities, indicated by
more than 3 signal faults of the
same time within 5 minutes.
Alarm clears when there are less
than 3 faults in a 5 minute
period.
MTIE The specified input port has
exceeded at least 1 of the MTIE
alarm thresholds.
E422 The EIA-422 Output is not
FAULT functioning properly.
S1LOS LOS on Side 1
S2LOS LOS on Side 2
EXSLIP Excessive Slip Rate
RTM The Retimer module is not
FAULT functioning properly.
097-58001-02 Revision G – April 2008
T1
T1
T1
T1
AID = E422A, E422B, E422C, E422D
T1
AID = RTMA[-p], RTMB[-p], RTMC[-p], RTMD[-p]
T1
T1
T1
T1
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
AID Service
TYPE Affecting SSU
Mode
NSA MN
NSA MN
NSA MN
NSA MN
NSA NA
NSA MN
NSA NA
NSA NA
NSA NA
Alarm Level
PRR SUB
Mode Mode
MN MN
MN MN
MN MN
MN MN
NA NA
MN Mn
NA NA
NA NA
NA NA
TimeProvider User's Guide 183