Symmetricom EDGE CLOCK 1000 User Manual page 179

Table 6-7. Alarm Codes (Continued)
Event ID Description
ANT GPS antenna fault due to loss
COMM of communications.
GPS The GPS antenna position is
POS unknown.
GPS The current to the TPIU is either
PWR too high or too low.
GPSSYS An error occurred with BIST,
TRAIM, and/or UTC/ ephemeris
data.
GPSTRK The GPS engine is not tracking
any satellites.
INPDISQ The specified input has been
disqualified or qualified as a
possible system reference. The
fault condition must be
continuously present for the
FLTDELAY period before
disqualifying the input as a
possible reference. Once set,
this alarm clears when the input
is fault-free for the CLRDELAY
period.
INPLOS The 1 PPS signal has a LOS
fault. The fault must be continu-
ously present for the FLTDELAY
period before disqualifying the
input as a possible reference.
Once set, this alarm clears when
the input is fault-free for the
CLRDELAY period.
INPFRQ The specified input port's
calculated received frequency
is exceeding the pull-in range of
the LO. This condition
disqualifies the input as a
possible reference. Once set,
this alarm clears when the input
frequency is within the defined
pull-in range limits.
097-58001-02 Revision G – April 2008
Chapter 6 Maintaining and Troubleshooting the TimeProvider
AID Service
TYPE Affecting
EQPT NSA MN
EQPT NSA NA
T1 NSA MN
EQPT NSA MN
EQPT NSA MN
T1 NSA MN
T1 NSA MN
T1 NA NA
Troubleshooting the TimeProvider
Alarm Level
SSU PRR SUB
Mode Mode Mode
MN MN
NA NA
MN MN
MN MN
MN MN
MN MN
MN MN
NA NA
TimeProvider User's Guide 179