Rep 11.6.1 Stm Feed Clutch - Xerox WorkCentre 5020 Service Documentation

REP 11.6.1 STM Feed Clutch

Parts List on PL 11.6
Removal
To avoid personal injury or electrical shock, ensure that the machine is completely off
before disassembling or adjusting. Turn OFF the power and unplug the machine.
1. Remove the STM Rear Cover (PL 11.5).
2. Remove the gears (Figure 1).
1 Remove the E-rings.
2 Release the tabs.
Repairs and Adjustments
REP 11.6.1
WARNING
Figure 1
3. Remove the STM Feed Clutch (Figure 2).
1 Release the wire harness from the clamp.
2 Disconnect the connector.
3 Remove the screws (2).
4 Release the tab on the gear, and remove the gear together with the STM Feed Clutch.
5 Slide the wire harness through the hole.
Replacement
1. To install, do the removal steps in reverse order.
July, 2007
4-92
Figure 2
Initial Issue
WorkCentre 5020