Xerox WorkCentre 5020 Service Documentation page 233

NVM Settings Mode
Basic Operations of the NVM Settings Mode
The NVM Settings Mode allows you to check or change the value of each NVM setting.
Initially, the current value of the specified NVM item is shown as blinking.
Using the keypad to input a value shows the value as blinking.
Pressing the [C] button clears the value that was input and leaves the current value as blinking.
Pressing the [Start] button sets the value that was input, stops the blinking, and returns you to
the Function Code input screen after 2 seconds has passed.
If the [Start] button is pressed when "_" is displayed, or when the input value is outside the
range of possible settings, the input value is treated as invalid while the current value is shown
as blinking. You will then be returned to the Function Code input screen after 4 seconds has
passed.
See List of NVM Settings.
Initial Issue
WorkCentre 5020
3 3
3 3 1 3 3
3 3
3 3
July, 2007
6-11
General Procedures