Xerox WorkCentre 5020 Service Documentation page 256

Options
Product name Installation
User
STM (500sheets) O
Stand O
Warmup Time
In an ambient environment of 22°C and 55% R.H. and in the power off or power save mode,
the machine will reach a "ready to copy" condition within 45 seconds.
Low Power Mode
When the machine is not operated for a certain period of time, the machine enters Low Power
Mode automatically.
Control Panel: LED: ON
Device Control: The fuser reduces its temperature.
Printer I/F: Activated status.
After a certain amount of time in Standby Mode, the machine enters Low Power Mode. This
time can be changed by a software program (setting range: 0-240 minutes). The factory
default is 5 minutes.
Low Power Mode is cancelled when a button is pressed on the Control Panel or when a printer
job is received.
Sleep Mode (Off Mode)
The machine operates as follows to save power when the machine is in Low Power Mode for a
specified time:
• Control Panel: LED: OFF, Power Save Button: ON
• Device Control: Power is turned off (except for warmup).
After a certain amount of time in Low Power Mode, the machine enters Sleep Mode. This time
can be changed by a software program (setting range: 0-240 minutes). The factory default is 5
minutes.
Sleep mode is cancelled when a button is pressed on the Control Panel or when a printer job is
received. When Sleep Mode is cancelled, the machine returns to Standby Mode.
Time to transfer to Standby Mode shall be 45 seconds or less (on standard configuration).
FCOT (Warm Start)
FCOT: First Copy Output Time
General Procedures
Table 5
Code
EL200735
EL200736
FCOT shall be 7.5 sec or less. FCOT (Warm Start) is measured from the time the Start button
is pressed (when the engine receives a START command in the "STAND-BY" state) till the trail
edge of the first sheet is fed out, under the following conditions:
– Documents are placed on Platen
– Power is on
– Engine motor is not running
– Fuser is ready
– Laser scanner motor (ROS: Raster Output Scanner) is ready
– Paper size and feeding orientation: A4 or 8.5x11 LEF
– Paper tray: Tray 1
FPOT
FPOT: First Print Output Time
FPOT shall be 12sec or less
Resolution
Copy print: 600 X 600 dpi. Printer print: 600 X 600 dpi.
Read Rate
TBD
Software Download
Controller Part: User can upgrade the software by downloading the object from the PC.
IOT Engine Part
MCU: Replacing the board. Optional Tray: Replacing the board.
Count-up for Print/Copy jobs: GDI
The purpose of the Count-up Meter is to categorize the number of sheets of print output by
print job, copy job, and test prints (Diagnostic Mode). The NLM Count-up Meter is not guaran-
teed as a meter for billing purposes. The Count-up Meter is managed by the device unit and
can be confirmed with device UI.
The Count-up Meter has only one total counter.
Job type Counter type
Copy Total Counter
Print
Diag
Report: One (Printer).
July, 2007
6-34
Table 6
Description
Counter of copy job
Counter of print job
Test print in Diag mode
(It doesn't contain the Diag test print with Type-Di.)
Initial Issue
WorkCentre 5020